WHAT IT DOES
The AEM Water/Methanol Injection Filter is an in-line filter that uses a micronic mesh screen to filter particulates as small as 40 microns. This allows a cleaner flow of water/methanol to be passed into the engine, not only protecting the internals of the engine itself, but also the working parts of the water/methanol pump, too. Run the AEM Water/Methanol Injection Filter in-line before the pump to protect both pump and engine. 

WHY YOU WANT ONE
If you are using a Water/Methanol Injection System it may greatly increase pump life to use a water/methanol filter. The AEM Water/Methanol Injection Filter prevents foreign particles as small as 40 microns from clogging or damaging pumps, injection nozzles check valves or flow sensors. The AEM Water/Methanol Injection Filter uses fittings for use with 1/4" OD nylon tubing, so it fits most Water/Methanol injection kits on the market today!

PRODUCT FEATURES

	Simple to install, takes less than a minute!
	Fits virtually every Water/Methanol system on the market.
	Polypropylene housing - rugged material that is compatible with high concentrations of methanol.
	Completely Serviceable Assembly - can be disassembled, cleaned and reused for a long service life.
	Stainless Steel mesh strainer - AEMs custom mesh strainer filters down to 40 microns - MUCH smaller than similar filters.
	Large Filtering Area assure long service life and does not significantly reduce flow.
	Micronic Mesh Screen out-performs sintered filters in both filtering and serviceability.

 

PRODUCT CONTENTS

Important Safety Notice Regarding Methanol
 
AEM strongly recommends that users never exceed a 50% methanol concentration when using any AEM Water Methanol system or component.
 
All AEM Water/Meth injection systems and components (pump, lines, fittings, filter, flow sensor, tank, and nozzles) are 100% chemically compatible with methanol. However, for safety reasons we strongly recommend that users never use more than a 50% methanol concentration in our systems.
 
Methanol is a toxic and highly flammable chemical. 100% Methanol ignites easily and burns vigorously with an almost undetectable flame. Methanol can be absorbed through the skin and even x-small amounts can cause blindness or even death. Using this fluid at high pressures, without dilution, in an under-hood environment with nylon lines and push-to-connect fittings is very unsafe. The performance advantages of using greater than 50% methanol concentrations are x-small, if they exist at all. However, the safety issues are very real and far out weigh any perceived benefit of running high concentrations of methanol.

WARNING!

Improper installation and/or adjustment of this product can result in major engine/vehicle damage.  For technical assistance visit our forum at http://forum.aempower.com/forum/index.php or visit our dealer locator http://www.aemelectronics.com/dealer_locator.php to find a professional installer/tuner near you.
 
Note: AEM holds no responsibility for any engine damage or personal injury that results from the misuse of this product, including but not limited to injury or death caused by the mishandling of methanol.