what nozzle size should i be using? | AEM
2 posts / 0 new
Last post
msport335
Offline
Last seen: 2 years 3 months ago
Joined: 08/19/2016 - 20:40
what nozzle size should i be using?

 

currenly running 400whp on my 94 octane tune and about 485whp on my e85 tune....  am i safe running the 1000cc nozzle?  peak boost the car sees is about 22.5psi and im running 50/50 mix of water/meth

 

any insight would be appreciated

AEM_NS
Offline
Last seen: 5 hours 28 min ago
Joined: 06/06/2014 - 09:31
You may have seen this table

You may have seen this table in the instructions:

Assuming 450-500hp at that boost, 1000 cc/min should be just right.  The general rule of thumb is to run as much water/methanol as you can without inducing misfire.  Monitor AFRs and air temps to see what effect different flow rates have.