13b rotary injection timing angle. | AEM
2 posts / 0 new
Last post
Wankel88
Offline
Last seen: 2 months 2 weeks ago
Joined: 09/22/2016 - 22:45
13b rotary injection timing angle.

I've been looking into this and trying to get a grasp from all the information I've collected so far. Using the standard rotary base session the phasing is set to 180 deg between my primary injectors. What does this correlate to for my end of injection timing? Everything I've read has been for piston engines and I get very confused in translation.

I've found numbers posted on various websites in what some would start with and tweak from there.

If my fi timing table is set all to 0, what would be my end of injection angle?

AEM_SB
Offline
Last seen: 2 months 2 weeks ago
Joined: 06/07/2014 - 14:29
You're in luck, this has been

You're in luck, this has been covered in detail with a rotary-specific example:

https://www.aemelectronics.com/forum/mazda-rx7-fd-2-rotor-injection-angle