1G DSM Instructions Help? | AEM
3 posts / 0 new
Last post
Dave W.
Offline
Last seen: 4 years 5 months ago
Joined: 10/05/2014 - 12:10
1G DSM Instructions Help?

I just picked up AEM EMS Series2 for a 1G DSM,  # 30-6300.  Where can I find instructions to configure this ecu?  I was able to port the maps over from my old Series 1 ecu, but I'm not sure how to configure the output to trigger a second fuel pump. I was using pin #62  on the Series 1 and I see that it's also available on Series 2, but I'm not sure how to configure the settings to trigger LS4 on the new ecu. Any help would be welcome.

Thanks! 

If it matters, the stickers on the side of the box say 'REV: C'  'MODS: A'

AEM_GN
Offline
Last seen: 4 years 4 months ago
Joined: 02/18/2014 - 09:55
The get installed on your

The get installed on your local hard drive when you install the software. Navigate to C: -> Program Files (x86) -> AEM -> AEMTuner -> Instructions.

Dave W.
Offline
Last seen: 4 years 5 months ago
Joined: 10/05/2014 - 12:10
aha, there it is. Thanks! 

aha, there it is. Thanks!