1g DSM Version 2 EMS no TPS ? | AEM
4 posts / 0 new
Last post
WhiteBish
Offline
Last seen: 2 years 4 months ago
Joined: 02/10/2018 - 16:41
1g DSM Version 2 EMS no TPS ?

Upon putting the car back together this year I redid all the wiring on the car to clean up the previous harness that was there before. Im 99.9% sure i put everything back together as it was before, I labeled everything very well . The issue im having is that im not getting any TPS signal. I give it a lil throttle and it pops and shuts off almost immediately. It is wired correctly , 5v, TPS signal and sensor ground. once i connect the laptop it shows zero on the TPS tab. I changed out the TPS and same issue. What could my issue be and how can I go about fixing it? any help is appeciated.

AEM_NS
Offline
Last seen: 30 min 34 sec ago
Joined: 06/06/2014 - 09:31
What's the TPS voltage do

What's the TPS voltage do when you move the throttle?

Sc300nat
Offline
Last seen: 1 year 8 months ago
Joined: 09/22/2018 - 10:36
I'm having the Sam problem my

I'm having the Sam problem my volts is 0.10 closed throttle and 0.18 full throttle

Sc300nat
Offline
Last seen: 1 year 8 months ago
Joined: 09/22/2018 - 10:36
I'm having the Sam problem my

I'm having the Sam problem my volts is 0.10 closed throttle and 0.18 full throttle