4 posts / 0 new
Last post
turbogate
Offline
Last seen: 1 week 1 day ago
Joined: 08/09/2015 - 07:40
ADCR14 30-6100 box question

Sorry if this has been beaten to death already.  I searched with no definite answer.  Installing an AEM oil temp sensor on the Supra 30-6100 box.  Instructions manual reads "Available 0-5V input, 2.2k pull up to 5V" for pin 24B (ADCR14).  Am I good to go using that pin which is available meaning no additional 2.2k resistor needed? 

Thanks

 

AEM_NS
Offline
Last seen: 1 day 20 hours ago
Joined: 06/06/2014 - 09:31
turbogate wrote: Am I good to

turbogate wrote:
Am I good to go using that pin which is available meaning no additional 2.2k resistor needed? 

Yes.

turbogate
Offline
Last seen: 1 week 1 day ago
Joined: 08/09/2015 - 07:40
Thank you for confirming! I'm

Thank you for confirming! I'm using the 30-2013 sensor and don't believe it's in the Wizard and it looks like the specs are different then the 30-2012 based on this other thread.  Does that just mean I need to manually set-up the cal table I assume?

Thanks again!

AEM_NS
Offline
Last seen: 1 day 20 hours ago
Joined: 06/06/2014 - 09:31
If you compare the sensor

If you compare the sensor calibrations you'll see that the 30-2013 is practically the same as the 30-2011 so just pick that one in the wizard.