AEM - Water / Meth Controller Flashing 2 Times for Open Circuit | AEM
2 posts / 0 new
Last post
ClearwaterSHO
Offline
Last seen: 1 month 3 weeks ago
Joined: 06/14/2020 - 06:13
AEM - Water / Meth Controller Flashing 2 Times for Open Circuit

Hello Everyone, 

 

  I recently purchased an AEM V2 1 Gallon Water/Methanol Injection Kit (Internal Map) to install on my 2013 Taurus SHO. I got everything wired in and was ready to test / flush the system. To my dismay, I plugged the wiring harness into the controller only to be met with an open circuit flashing light. I said okay, first things first, I'll check the fuse on teh controller. I checked it, fuse isn't blown and tested to have continuity. Next I removed the wiring that ran back to the trunk where the pump is located, and tested the orange and pink wire for continuity to ensure the issue wasn't with the wire. I can confirm there is not an issue with the wires that run back to the pump. At this point, I'm at a loss on what else to look for to why the circuit is open.  The only thing I have been able to find with someone having a similiar issue was on this forum and they were instructed to reach out to AEM for assistance on getting a new controller sent out. Has anyone else had this issue, if so, what was the issue? 

AEM_NS
Offline
Last seen: 41 min 48 sec ago
Joined: 06/06/2014 - 09:31
Contact Tech Support: 1-800

Contact Tech Support: 1-800-423-0046