AEM Wideband-Sensor placement on open Headers? | AEM
2 posts / 0 new
Last post
Elkwagn
Offline
Last seen: 1 month 2 weeks ago
Joined: 08/04/2020 - 18:13
AEM Wideband-Sensor placement on open Headers?

Like the topic says, where is a good placement on open headers, and will it even work properly?

Travis4380
Offline
Last seen: 1 month 3 days ago
Joined: 08/19/2020 - 19:05
You want it right after the 4

You want it right after the 4 primary’s come into the collector But usually about 3” before the open end of header if possible. But be aware with headers you may get lean readings at idle due to sensor being close to open air. But under throttle you should be fine. You also want to make sure the sensor is put in the top side of the header so it can collect moisture.