6 posts / 0 new
Last post
rawkus
Offline
Last seen: 4 months 1 week ago
Joined: 05/26/2015 - 05:59
AQ-1 and V96.1

Is it possible to datalog all the new channels available from the Infinity via CAN? Thanks!

Dan

rawkus
Offline
Last seen: 4 months 1 week ago
Joined: 05/26/2015 - 05:59
Also, the AQ-1 doesn't appear

Also, the AQ-1 doesn't appear to be datalogging any of the ADCR channels' voltages. They all read 0.0 even if the Infinity shows a voltage. Air temp, voltage, coolant temp, load, rpm, ignition timing, O2, throttle and vehicle speed all work fine. I am basing all of what should be read through the ADCR channels via the following infromation:

(these channels get broadcast on MessageID 0x01F0A001)

Series2  ADCR11 (bytes0-1)   >>   Infinity Analog09 Volts  (pin C1-37)   =   Fuel Pressure  volts

Series2  ADCR13 (bytes2-3)   >>   Infinity Analog10 Volts  (pin C1-38)

Series2  ADCR14 (bytes4-5)   >>   Infinity Analog11 Volts  (pin C1-39)

Series2  ADCR17 (bytes6-7)   >>   Infinity Analog12 Volts  (pin C1-40)

 

(these channels get broadcast on MessageID 0x01F0A002)

Series2  ADCR18 (bytes0-1)   >>   Infinity Analog13 Volts  (pin C2-18)  =   Oil Pressure volts

Series2  ADCR15 (bytes2-3)   >>   Infinity Analog14 Volts  (pin C2-19)

Series2  ADCR16 (bytes4-5)   >>   Infinity Analog15 Volts  (pin C2-20)

Series2  ADCR08 (bytes6-7)   >>   Infinity Analog16 Volts  (pin C1-21)

AEM_NS
Offline
Last seen: 1 year 3 months ago
Joined: 06/06/2014 - 09:31
There will need to be an AQ-1

There will need to be an AQ-1 update in order to get the analog channels working again.  This is on our radar but no ETA at the moment. I'll update once I know more.

rawkus
Offline
Last seen: 4 months 1 week ago
Joined: 05/26/2015 - 05:59
Ok... will the AQ-1 be able

Ok... will the AQ-1 be able to handle all the V96.1 CAN channels in the future? Thanks for the update.

 

Dan

AEM_NS
Offline
Last seen: 1 year 3 months ago
Joined: 06/06/2014 - 09:31
Yes.  That's what I meant by

Yes.  That's what I meant by needing an update.  We need to update the AQ-1 to accept the updated Infinity AEMnet protocol.

rawkus
Offline
Last seen: 4 months 1 week ago
Joined: 05/26/2015 - 05:59
Good news, I will be patient

Good news, I will be patient in the mean time! If at the same time you could implement a start logging feature based on AEMnet TPS %, that would be sweet.