5 posts / 0 new
Last post
Ratbert
Offline
Last seen: 6 months 4 weeks ago
Joined: 09/27/2016 - 13:32
AQ-1 GPS Time Sync

I have an AQ-1 and a Vehicle Dynamics module hooked up to my AEMNet bus.  WIthin the AQ-1 setup dashboard I have told it to sync time to the GPS time and while I have the laptop dashboard app open it appears to do so.  However when I later pull log files off of the AQ-1 they all have the default date/time as the filename timestamp.  I am waiting until the GPS signal is fully established before I turn on the AQ-1's logging switch (I'm using Digital 1 to trigger logging).  Is there something else I've missed to make it synchronize time properly when the laptop dashboard app isn't connected?

Ratbert
Offline
Last seen: 6 months 4 weeks ago
Joined: 09/27/2016 - 13:32
Since I hadn't heard anything

Since I hadn't heard anything on this, I tried messing around with it more.  I discovered that it shows the correct date/time from GPS in the AEMNet channels list after auto-discovering the VDM but doesn't seem to ever actually sync to AEMNet GPS even though that is selected from the dropdown list.  It does show the example filename for the log file using the correct date and time but I'm unclear if that is something that is generated by the dashboard software on the laptop or the AQ-1 itself.  I'm guessing the AQ-1. 

Ratbert
Offline
Last seen: 6 months 4 weeks ago
Joined: 09/27/2016 - 13:32
Am I the only one having

Am I the only one having problems getting the AQ-1 to time sync to the GPS time from the VDM, or is this just not a supported configuration?

 

smlopez383
Offline
Last seen: 8 months 1 week ago
Joined: 01/30/2018 - 09:16
I'm showing the same problem

I'm showing the same problem on my GPS also. I have'nt spent a lot of time messing with this as I'm fighting noise issues. But ill dig into it this coming up week and share my findings. 

 

pioneer1004
Offline
Last seen: 1 month 3 weeks ago
Joined: 09/03/2015 - 18:52
I am also showing this

I am also showing this problem.  Possibly after the last firmware updates, it keeps going to the default value. Did anyone get tp fix this is its super annoying?