2 posts / 0 new
Last post
Radamx2
Offline
Last seen: 3 years 7 months ago
Joined: 02/03/2016 - 13:30
AQ1 to series 2

What is the best way to connect it to a 6050 box..

I was hopeing to wire it direct with the CAN BUS 2 lead. In the instructions it says not used so Can I use it.

If not which is better, serial connect or should I install a connector for the CAN bus

Also for the CAN bus do I use CAN H to CAN H or L ,and do I need to Have power and grd from ECM

I just want to build this harness right the first time

Thanks

Kevin

AEM_NS
Offline
Last seen: 1 year 2 months ago
Joined: 06/06/2014 - 09:31
Only need to connect two

Only need to connect two wires: CAN H to CAN H and CAN L to CAN L.  On a 6050 CAN H is D10 and CAN L is D14.  The AQ-1 needs it's regular power and ground connected though.