8 posts / 0 new
Last post
ScSmooth
ScSmooth's picture
Offline
Last seen: 5 years 6 months ago
Joined: 10/26/2014 - 09:01
Cannot Read or Write to AEM EMS - No File For ECU Version

I recently bought a used AEM EMS and was finally trying to get it to work on my car. I can connect to the EMS. When I try to send the start up cal I get a popup said: No File For ECU Version. I then tryed running the ECU Setup Wizard just said: Could Not Find AEM Configuration File. How can I fix this? Thank you for any help. 

 

 

AEM_PT
Offline
Last seen: 1 month 2 days ago
Joined: 05/22/2014 - 08:13
What is the serial number on

What is the serial number on the side of your box? You may need to update the firmware on the unit before loading a calibration.

ScSmooth
ScSmooth's picture
Offline
Last seen: 5 years 6 months ago
Joined: 10/26/2014 - 09:01
Serial # 1310-0387  

Serial # 1310-0387

 

AEM_PT
Offline
Last seen: 1 month 2 days ago
Joined: 05/22/2014 - 08:13
When you open AEM Pro, you

When you open AEM Pro, you are going to go directly to ECU and then scroll down and select "Update EMS Firmware."

If you open your instructions folder located in your AEM Pro folder, you will find a few small files that will be labeled "V1.XX Conversion Notes.pdf"

ScSmooth
ScSmooth's picture
Offline
Last seen: 5 years 6 months ago
Joined: 10/26/2014 - 09:01
I will try that this weekend.

I will try that this weekend. I'll let you know if it works.

supercompact
Offline
Last seen: 3 weeks 3 days ago
Joined: 03/12/2017 - 06:50
I'm having this same exact

I'm having this same exact issue.  I get the same error even if it's not plugged into the ecu at all.  I think it's a problem with the software.  Same error on WIndows 10 or Windows XP.

Knox839
Offline
Last seen: 3 months 3 weeks ago
Joined: 04/15/2019 - 03:17
AEM_PT wrote:

AEM_PT wrote:

When you open AEM Pro, you are going to go directly to ECU and then scroll down and select "Update EMS Firmware."

If you open your instructions folder located in your AEM Pro folder, you will find a few small files that will be labeled "V1.XX Conversion Notes.pdf"

 

I tried this but I'm having same issue again. "no file for this ecu version". So it looks like old tuner locked the ems for no one see his map. Is there a way like master reset etc and tune with aem's startup calibrations ? 

 

Knox839
Offline
Last seen: 3 months 3 weeks ago
Joined: 04/15/2019 - 03:17
 

 

ScSmooth wrote:

I will try that this weekend. I'll let you know if it works.

did you sort it ?