CD-7 Dash error message | AEM
3 posts / 0 new
Last post
Blown 5.0
Blown 5.0's picture
Offline
Last seen: 8 months 23 hours ago
Joined: 01/15/2015 - 13:08
CD-7 Dash error message

Hello, This is a new installation and 'm having trouble uploading and downloading the setup files to and from CD-7 Dash. I'm getting an error message when I try. The DashDesign software is linking to CD-7 and I'm getting a green dash (AEM CD-7 connected) light at the laptop when I connect the usb. I flashed with the latest firmware (CD-14x20) using the latest DashDesign software version 1.04.07. The error message I get when I connect the usb cable is "No applet logs present" and if I try to download I get "Setup is not downloadable"

 

CD-7 error display.pdf

 

AEM_HB
Offline
Last seen: 1 hour 11 min ago
Joined: 11/07/2016 - 09:22
 

 

Hey Blown5.0

Are you able to open a new setup for your application in the dash design software and upload it to the display? 

Do you have a logging dash or a non-logging dash? 

Blown 5.0
Blown 5.0's picture
Offline
Last seen: 8 months 23 hours ago
Joined: 01/15/2015 - 13:08
Yes, I'm able to open any

I have the non-logging 30-5502 dash with a vehicle dynamics module. Yes, I'm able to open any existing layout in the Dash design software but I cannot upload it to the display, it also won't download from the display to my PC. I'm using a bulkhead USB communication cable from the dash to a fixed mounting point and from there I plug in with a USB cable to my PC. I know that the dash is connecting and communicating with the Dash design software since I was able to update the firmware and was also able to set the time and date to the same as the PC. The CD-7 dash is also wired to an Infinity 8 (30-7101) ECU using the "Typical" CAN1 plug and play setup.