Conversion to dash design 2.0 AnalogResistance channels odd | AEM
1 post / 0 new
TME
Offline
Last seen: 9 months 5 days ago
Joined: 10/26/2017 - 16:07
Conversion to dash design 2.0 AnalogResistance channels odd

Had installed the Dash design 2.0 and opened the design made in previous version. The AnalogResistance channels of 22-channel module were quite odd as these had not the extra channel with the conversion as setup on previous version to convert the raw signal to a physical value by a calibration table that I had setup in the old design. For other channels like the AnalogVoltage there was such extra channel. Strangely the AnalogResistance which then suppsingly would be the raw CAN input signals did not show raw values but the converted as were setup in the old design...?  Now this isn't that great when later you want to change the setup. Is this a known issue?  But more important can I fix this in my current design setup?

Best regards, Theo