Direct port injection setup/size | AEM
4 posts / 0 new
Last post
Coxy468
Offline
Last seen: 2 months 2 weeks ago
Joined: 04/14/2020 - 09:41
Direct port injection setup/size

Hi I just recently purchased the v2 1 gallon kit 30-3300 yet to be fitted, I have also purchased a new inlet manifold so that I can run it as a direct port injection my question is will this kit run 4 jets? If so is it a case of just buying 3 x 30-3312 kits and using the supplied 'T' pieces and just teeing off for each injector or will I need a 4 port manifold so they all run from the same place?

and lastly with these injectors do the pipes going to each injector have to be the same length? And what nozzle sizes do you recommend running around 580bhp

Thanks

james

Username
Offline
Last seen: 2 months 1 day ago
Joined: 01/05/2017 - 08:59
Sure you could do it. I'm

Sure you could do it. I'm guessing that under high vacuum it would probably suck in some water/meth. 

you could either make a manifold or with t's a manifold should have more consistent pressure. 

nozzle size? different engines will require different things. 

page 11 of the instructions will probably help you out a lot.

https://www.aemelectronics.com/files/instructions/30-3300-Water-Methanol-Injection-Kit-V2-Standard-Controller-Internal-MAP-1.15-GAL-Tank.pdf

 

Coxy468
Offline
Last seen: 2 months 2 weeks ago
Joined: 04/14/2020 - 09:41
Thanks for the reply I have a

Thanks for the reply I have a 4 port manifold now and have also ordered your solenoid, looking at the graph it will be running near 600hp with about 34psi of pressure it's says 1322, what 4 nozzles would you recommend ?

Coxy468
Offline
Last seen: 2 months 2 weeks ago
Joined: 04/14/2020 - 09:41
Bump 

Bump