E46 PNP/CD7 and VDM | AEM
3 posts / 0 new
Last post
Andrew C
Offline
Last seen: 3 months 1 week ago
Joined: 09/21/2014 - 09:34
E46 PNP/CD7 and VDM

Just completed the initial start of the race build, and we need to wire the VDM to the CD7 and infinity8 (E46 PNP).   Looking at the wiring for all these componeints in their respective manuals, I would expect there to be two CAN plugs on one of the harnesses to allow the VDM and dash to recieve and send data?  I am the car owner, and the shop that installed the ECU and dash omitted the VDM during ithe inital build.  I will need to add the VDM as soon as the alignment is completed.

 

  Any advise would be great.

Andrew

AEM_HB
Offline
Last seen: 18 hours 9 sec ago
Joined: 11/07/2016 - 09:22
Does your VDM have the Y

Does your VDM have the Y-cable with a male and female AEMnet connectors?

If so, unplug the dash from the ecu harness. Then plug one end of the vdm into the ecu harness and the other into the CD-7 dash harness. 

Andrew C
Offline
Last seen: 3 months 1 week ago
Joined: 09/21/2014 - 09:34
Done, and thanks.

Done, and thanks.

Works as advertised.