Infinity 506 main relay question for a J35 engine | AEM
4 posts / 0 new
Last post
67bajaj35
Offline
Last seen: 1 month 5 days ago
Joined: 10/11/2019 - 16:42
Infinity 506 main relay question for a J35 engine

Hello AEM,  I’m in the process of wiring my infinity 506 using your 30-3706 harness for my Honda j35 project. After reviewing the 3 wire smart coil diagram, can I use the main relay to power the coils and injectors from circuit R87 that feed C1-63&68? Or do I need to add additional relays for coils and injectors. Side note I will not be using it to power fuel pumps or fans. Thanks for your time. Brent 

 

 

 

67bajaj35
Offline
Last seen: 1 month 5 days ago
Joined: 10/11/2019 - 16:42
Any help would be appreciated

Any help would be appreciated. Thanks

AEM_SB
Offline
Last seen: 2 months 2 weeks ago
Joined: 06/07/2014 - 14:29
It should be OK to power 6

It should be OK to power 6 high-impedance injectors (10-12 ohms each) from that little main relay that comes with the 30-3706 harness. I wouldn't feel comfortable using it to power 6 coils, add a separate relay for those. You can use it to power your IAC valve, since that should draw around 1-2 amps max.

 

Hope that helps,

SB

67bajaj35
Offline
Last seen: 1 month 5 days ago
Joined: 10/11/2019 - 16:42
Helped out a bunch! Thank you

Helped out a bunch! Thank you sir for getting back to me. This just confirms, I like redundancy. I’m going to run fuses and relays for each. I’m sure I’ll have more questions, but points me in the right direction. Brent