Infinity 6 model id invalid error | AEM
3 posts / 0 new
Last post
Davin Virgo
Offline
Last seen: 3 months 1 week ago
Joined: 04/25/2020 - 14:51
Infinity 6 model id invalid error

Good day I have an Infinity 6 installed and read for use. I registered the ecu and downloaded the firmware as instructed to do, however whenever I try to upgrade the firmware I get an immediate error prompt stating model id is invalid. 

I do not know how to solve this issue, I am running infinity tuner on Windows 10. The program connects to the ecu and shows the type of ecu but it just wont allow me to upgrade the firmware.

Davin Virgo
Offline
Last seen: 3 months 1 week ago
Joined: 04/25/2020 - 14:51
So I’ve got the firmware

So I’ve got the firmware upgraded, I have a 1.5 jz-gte vvti setup with 6 Toyota 1NZ coil, I got a start up map from a tuner. I loaded the map to ecu, the problem I am facing now is that whenever I try to start I’m only getting spark from coil pack 3 and 4. The settings is set to wasted spark. I am not sure why I’m getting spark from only 2 coil.

Def
Offline
Last seen: 6 days 18 hours ago
Joined: 09/14/2014 - 10:21
Are you getting full sync?

Are you getting full sync? Look at CamCrank tab on AllTabs layout.

 

On a 4 banger, pack 3 and 4 would typically be on two entirely different cycles, so I'd think that'd be full 100% start probability. Have you double checked your wiring?