Knock reading | AEM
4 posts / 0 new
Last post
evomasiluz
Offline
Last seen: 2 months 2 weeks ago
Joined: 09/07/2019 - 13:37
Knock reading

Good evening gentlemen. I need help reading the knock, I have an Infinity on my evo 8.
The problem is that it knocks only on cylinder 2 and on the other cylinders it marks 0. I have tried to solve the problem by changing the sensor for a flat response, but the readings are the same. How can i fix this????

AEM_NS
Offline
Last seen: 21 hours 7 min ago
Joined: 06/06/2014 - 09:31
Unfortunately the stock DSM

Unfortunately the stock DSM/Evo crank trigger pattern doesn't offer enough resolution to correctly control the knock windowing feature thus knock readings are usually not very good. This can be fixed by upgrading to an aftermarket high tooth count trigger setup.

evomasiluz
Offline
Last seen: 2 months 2 weeks ago
Joined: 09/07/2019 - 13:37
I understand. IBuy the Kiggly

I understand. IBuy the Kiggly Racing 12 tooth trigger kit. Could you support me with the configuration? or give me some guide to configure it in infinity.

AEM_NS
Offline
Last seen: 21 hours 7 min ago
Joined: 06/06/2014 - 09:31
Been covered a few times here

Been covered a few times here on the forum over the years. Try a search first but the setup is pretty straight forward. Post up any questions you might have if you run into trouble.