Subaru STI series 1 | AEM
5 posts / 0 new
Last post
edu01jose
Offline
Last seen: 3 years 5 months ago
Joined: 10/30/2014 - 09:27
Subaru STI series 1

Hello, I'm having a problem with AEM ems V1, it already has the update MOD A Rev C. I'm having a problem with the cam sensors. They are not reading anything, input stays at 0 on the AEM pro. I already shaved the sensor brackets and have a .030mm air gap on each side. Is there any value I should set? any tricks? I will upload a video showing what the AEM pro reads when car cranks. I have tried contacting AEM and their customer service sucks!

Anyways, Thanks!

Here's my setup:

-Brian Crower Stage 3 cams
-Supertech +1mm oversized valves
-Supertech springs & retainers
-Cosworth headgaskets
-ARP Head studs
-JE pistons
-Manley rods
-OEM Crankshaft
-OEM 11mm Oil pump
-OEM Gasket kit
-OEM Plastic Cam Sprockets
-Gates Racing timing belt kit
-OEM Oil cooler
-Borgwarner S300sx3 Turbo

 

Here's the video:
http://i697.photobucket.com/albums/vv339/edu01jose/IMG_2625_zps9l778o7j....

 

oscar
Offline
Last seen: 5 years 8 months ago
Joined: 10/24/2014 - 01:44
Have the internal 'jumpers'

Have the internal 'jumpers' been set to magnetic pickup configuration ?

 

edu01jose
Offline
Last seen: 3 years 5 months ago
Joined: 10/30/2014 - 09:27
Sir, how do I set the

Sir, how do I set the magnetic pickups? 

oscar
Offline
Last seen: 5 years 8 months ago
Joined: 10/24/2014 - 01:44
There is a whole lot of

There is a whole lot of information including jumper configuration here:

frown

edu01jose
Offline
Last seen: 3 years 5 months ago
Joined: 10/30/2014 - 09:27
I got around to setting that

I got around to setting that and stat sync is now ON. Still, I am not getting any spark or any sputter from the engine. Spark start also stays at 0.