Switch From AEM 1bar to to 3.5bar sensor | AEM
3 posts / 0 new
Last post
boostinben
Offline
Last seen: 4 years 8 months ago
Joined: 08/27/2015 - 09:22
Switch From AEM 1bar to to 3.5bar sensor

This maybe a dumb question, but I am looking to change my current Map sensor an AEM 30-2130-15  (1bar)  For the 30-2130-50 (3.5bar).

I am wondering what is involved in getting my AEM EMS 30-1601 V1 to recognize the new sensor and be able to read boost over 15psi? Is there some re-calibration? Change to the fuel cut? ..

any direction would be appreciated.. or along the same lines a knowlegeable person in the SF bay area  California who i can employ to make the change / re-tune.

thanks

Ben                            

AEM_NS
Offline
Last seen: 3 days 3 hours ago
Joined: 06/06/2014 - 09:31
Moving to Series 1 forum.

Moving to Series 1 forum.

boostinben
Offline
Last seen: 4 years 8 months ago
Joined: 08/27/2015 - 09:22
Can anyone help me out with

Can anyone help me out with this? I have gotten as far as figuring out that i need to re-align the fuel table to match the new sensor, i think maybe the boost fuel correct table? Timing table? is there any chance someone could walk me through a step by step?