Wiring Flex fuel sensor on the AEM 30-6100 | AEM
4 posts / 0 new
Last post
papagogo
Offline
Last seen: 6 months 5 hours ago
Joined: 10/28/2014 - 03:25
Wiring Flex fuel sensor on the AEM 30-6100

hi,

what pin i have to use to wiring the flex fuel sensor on my AEM ?

i read, pin 21B, but it seems to be for the A/T  , then i'm not sure ?? if it is this pin , i ve got a R154, then no problem to do, i have to know

thanks for your help !

AEM_NS
Offline
Last seen: 2 hours 4 min ago
Joined: 06/06/2014 - 09:31
21B is for auto trans but if

21B is for auto trans but if you're not using it then it's an available input.  The 02v02 documentation says that you can use either the T3/T4 inputs or Switches 2-6.  This would mean you could use 3A, 4A, 18A, 28A, 21B, & 23B. 

fine metric
Offline
Last seen: 3 years 4 months ago
Joined: 11/18/2015 - 21:21
And if your auto what are the

And if your auto what are the alternative option if keeping the following 3A, 4A, 18A,21B, & 23B?

AEM_NS
Offline
Last seen: 2 hours 4 min ago
Joined: 06/06/2014 - 09:31
The bad news here is that the

The bad news here is that the Supra auto trans isn't supported in the 02v02 firmware that supports flex fuel.