Topic / Topic starter Replies Last postsort ascending
Normal topic Switch From AEM 1bar to to 3.5bar sensor
by boostinben » Thu, 08/27/2015 - 09:33
2
by boostinben
Mon, 10/26/2015 - 20:59
Normal topic USB Serial Driver
by DrBrown54 » Thu, 10/08/2015 - 20:32
4
by kikis
Mon, 10/26/2015 - 12:53
Normal topic Fried my AEM?
by kikis » Sun, 10/25/2015 - 18:16
0
by kikis
Sun, 10/25/2015 - 18:16
Normal topic usb serial converter. getting parity errors
by Crazy3rdgen » Tue, 08/18/2015 - 07:00
6
by alexzlo
Wed, 10/14/2015 - 23:30
Normal topic Flash error on
by Meatwagon » Sat, 10/03/2015 - 16:21
0
by Meatwagon
Sat, 10/03/2015 - 16:21
Normal topic Reading an aem oil pressure sensor voltage? 2jz 30-1100
by spadednick » Thu, 10/01/2015 - 16:00
0
by spadednick
Thu, 10/01/2015 - 16:00
Normal topic Z31 RB20DET Wiring Pin out help
by garrettnelson26 » Sat, 09/26/2015 - 10:23
0
by garrettnelson26
Sat, 09/26/2015 - 10:23
Normal topic Aem EMS 1020-0360
by apollox » Wed, 09/23/2015 - 12:21
0
by apollox
Wed, 09/23/2015 - 12:21
Normal topic anyone want to critique my timing map?
by sen2two » Mon, 09/21/2015 - 19:56
0
by sen2two
Mon, 09/21/2015 - 19:56
Normal topic Vacuum/PSI readings... Baro Calibration?
by sen2two » Mon, 09/14/2015 - 08:33
2
by sen2two
Sat, 09/19/2015 - 07:00
Normal topic Can send new calibration, but old workmap is restored after power cycle
by tehk » Sun, 09/13/2015 - 11:03
1
by AEM_BB
Thu, 09/17/2015 - 16:20
Normal topic how to wire boost controller to pw2??
by Projectx » Sun, 09/13/2015 - 21:37
1
by Projectx
Tue, 09/15/2015 - 10:52
Normal topic Supra fuelcut at 5500rpm ? can't find the settin to shut it off
by ST-Autosport » Tue, 07/14/2015 - 10:51
3
by Zuesmk4
Tue, 09/15/2015 - 06:04
Normal topic Downloaded Cal. Name
by Fabry » Thu, 09/10/2015 - 13:39
1
by AEM_NS
Fri, 09/11/2015 - 08:36
Normal topic Had a starting issue now have a stay running issue. 2jz gte
by Noyz25 » Tue, 08/18/2015 - 06:33
1
by Noyz25
Fri, 09/04/2015 - 19:33
Normal topic No fuel signal while cranking?
by spadednick » Tue, 09/01/2015 - 21:48
1
by AEM_NS
Thu, 09/03/2015 - 09:10
Normal topic Changed injectors...strange effect on tune
by azfiveoh » Thu, 08/27/2015 - 07:44
0
by azfiveoh
Thu, 08/27/2015 - 07:44
Normal topic Problems sending new calibration... sometimes.
by sen2two » Tue, 07/28/2015 - 19:32
3
by Jared
Mon, 08/24/2015 - 17:03
Normal topic main fuel map question
by sen2two » Wed, 08/05/2015 - 16:08
4
by sen2two
Thu, 08/20/2015 - 18:03
Hot topic Ethanol concentration with Series 1?
by azfiveoh » Wed, 04/22/2015 - 16:12
19
by AEM_NS
Thu, 08/20/2015 - 14:25
Normal topic AEM V1 don´t Connect
by MR3s » Thu, 07/02/2015 - 11:46
5
by Noyz25
Tue, 08/18/2015 - 06:26
Normal topic knock set up
by sen2two » Tue, 08/11/2015 - 16:58
0
by sen2two
Tue, 08/11/2015 - 16:58
Normal topic Need help with fuel map
by Crazy3rdgen » Sun, 08/02/2015 - 20:38
8
by Crazy3rdgen
Tue, 08/11/2015 - 15:04
Normal topic o2 feedback working away from target
by mdlimy » Thu, 08/06/2015 - 11:16
2
by mdlimy
Thu, 08/06/2015 - 21:17
Hot topic INNOVATE MTX-L WIDE BAND O2 CAL TABLE
by 4G63 POWER » Thu, 07/16/2015 - 20:28
11
by AEM_GN
Tue, 08/04/2015 - 10:44
New posts
No new posts
Hot topic with new posts
Hot topic without new posts
Sticky topic
Locked topic
Subscribe to RSS - AEM Series 1 Plug & Play Programmable Engine Management System